2.5.4 Drawer Face Mounting Holes Compliance Standards AWI PremiumPending review AWI CustomPending review AWI EconomyPending review ADA StandardsN/A Specification+ add spec reference Notes / Requirements Mounting holes are drilled through the drawer box front on all drawers. Each mounting hole is matched by a pilot hole in the back of the drawer face. The pilot does not break through the exposed face. Holes sit 2½″ in from each outside edge of the drawer box, measured to hole centerline. Holes are centered on the height of the drawer box front. Two holes per drawer, one at each end. Drawings: DRAWER BOX FRONT (INSIDE FACE) CLEARANCE HOLE (2 REQ.) 2½″ 2½″ DRAWER BOX WIDTH EQ EQ MOUNTING HOLES (ELEVATION) PILOT HOLE IN BACK OF FACE DRAWER FACE DRAWER BOX FRONT CLEARANCE HOLE EXPOSED FACE MOUNTING HOLE (DETAIL)